Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

1. Remove the front wheelhouse panel. Refer to Wheelhouse Panel Replacement .
2. Disconnect the front side marker lamp electrical connector from the marker lens housing.

1

Pencil Brace Bolt (Qty: 2)

Tighten
10 N·m (89 lb in)

2

Lower Fender Flare Retainers (Qty: 2)

3

Front Wheel Housing Opening Flare Retainers (Qty: 11)

Tip

1. Pull the flare away from the vehicle slightly, use small needle nose plyers to depress the tabs on the retainers.
2. Pull front flare outward at the rear then rearward to release from under the edge of the front grille.
3. Transfer the front marker lamp lens housing to the new front flare.

4

Front Wheel Housing Opening Flare Assembly