| Table 1: | Body Control Module (BCM) |
| Table 2: | Instrument Panel Cluster (IPC) |
| Table 3: | Powertrain Control Module (PCM) |
The scan tool data lists contain all of the Instrument Panel, Gages, and Console related parameters that are available on the scan tool. The parameters in the list are arranged in alphabetical order. The data list column indicates the location of the parameter within the scan tool menu selections.
Use the scan tool data lists as directed by a diagnostic table or in order to supplement the diagnostic procedures. Begin all of the diagnostic procedures with Diagnostic System Check - Vehicle in Vehicle DTC Information.
Use the scan tool data lists only after the following is determined:
| • | There is no published DTC procedure nor published symptom procedure for the customer concern. |
| • | The DTC or symptom procedure indicated by the Diagnostic System Check does not resolve the customer concern. |
The typical data values are obtained from a properly operating vehicle under the conditions specified in the first row of the scan tool data list table. Comparison of the parameter values from the suspect vehicle with the typical data values may reveal the source of the customer concern.
Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
Operating Conditions: Ignition ON/Engine OFF/Headlamps Off/Doors Closed/Park Brake Unapplied | |||
Battery Voltage Signal | Data | Volts | 12.2 V |
Cargo Lamp Switch | Inputs | Active/Inactive | Inactive |
Courtesy Lamp Output | Outputs | On/Off | Off |
Courtesy Lamp Switch | Inputs | Active/Inactive | Inactive |
Driver Door Ajar Sw | Inputs | Door Ajar/Door Closed | Door Closed |
Hazard Lamp Switch | Inputs | Active/Inactive | Inactive |
Headlamp Off Switch | Inputs | Active/Inactive | Inactive |
Headlamp On Switch | Inputs | Active/Inactive | Inactive |
Headlamp Relay | Outputs | On/Off | Off |
High Beam Indicator Command | Outputs | On/Off | Off |
High Beam Select Switch | Inputs | Active/Inactive | Inactive |
Ignition Accessory | Inputs | Active/Inactive | Active |
Ignition 1 Run/Crank | Inputs | Active/Inactive | Active |
Ign. Off/Run/Crank | Inputs | Active/Inactive | Active |
LF Turn/Hazard Lamp Command | Outputs | On/Off | Off |
LR Turn/Hazard Lamp Command | Outputs | On/Off | Off |
Park Brake Switch | Inputs | Applied/Released | Released |
Park Lamp Signal | Outputs | On/Off | Off |
Park Lamp Switch | Inputs | On/Off | Off |
Passenger Door Ajar Sw | Inputs | Door Ajar/Door Closed | Door Closed |
RF Turn/Hazard Lamp Command | Outputs | On/Off | Off |
RR Turn/Hazard Lamp Command | Outputs | On/Off | Off |
Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
Operating Conditions: Ignition ON/Engine OFF/Seat Belt Buckled/High Beams Off/Park Brake Unapplied | |||
Battery Voltage | Data | Voltage | 12.2 V (Varies) |
Engine Coolant Temperature | Data | Celsius (Fahrenheit) | Varies |
Engine Speed | Data | RPM | 0 RPM |
Fuel Level | Data | % | Varies |
PRNDL Switch | Inputs | Park, Reverse, Neutral, Drive, 3rd, 2nd, 1st | Park |
Trip Odometer | Data | kilometers (miles) | Varies |
Trip Reset Switch | Inputs | Active/Inactive | Inactive |
Vehicle Speed | Data | kilometers per hour (miles per hour) | 0 mph (0 km/h) |
Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
Operating Conditions: Engine Idling/Normal Operating Temperature | |||
ECT Sensor | Engine Data EVAP Data Fuel Trim Data HO2S Data Ignition Data Misfire Data TAC Data IPC Data | Celsius (Fahrenheit) | 85-105°C (185-220°F) |
Engine Oil Life Remaining | IPC Data | Percent | 0-100% (Varies) |
Engine Oil Pressure Switch | Engine Data Misfire Data IPC Data | OK/Low | OK |
Engine Speed | Engine Data EVAP Data Fuel Trim Data HO2S Data Ignition Data Misfire Data Cruise Control Data TAC Data HVAC Data IPC Data | RPM | ±100 RPM from desired idle speed |
Fuel Level Sensor | EVAP Data IPC Data | Voltage | 0-5 V (Varies) |
Fuel Tank Level Remaining | Engine Data Misfire Data IPC Data | Percent | 0-100% (Varies) |
Ignition 1 Signal | Engine Data EVAP Data Fuel Trim Data H2OS Data Ignition Data Misfire Data Cruise Control Data TAC Data Electrical/Theft Data HVAC Data IPC Data | Voltage | 12.2 V (Varies) |
MIL (Malfunction Indicator Lamp) Command | Engine Data EVAP Data Ignition Data IPC Data | On/Off | Off |
Reduced Engine Power | TAC Data IPC Data | Active/Inactive | Inactive |
Vehicle Speed Sensor | Engine Data EVAP Data HO2S Data Ignition Data Misfire Data Cruise Control Data TAC Data HVAC Data IPC Data | km/h (mph) | 0 km/h (0 mph) |
