GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2007 🢒 H3 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Accelerator Pedal Position Sensor Replacement

Removal Procedure

    Object Number: 1560064 Size: SH
  1. Remove the knee bolster bracket. Refer to Driver Knee Bolster Bracket Replacement .
  2. Disconnect the accelerator pedal position (APP) sensor electrical connector.

    3. Object Number: 1560065 Size: SH
  3. Remove the accelerator pedal/APP sensor nuts.
  4. Remove the accelerator pedal/APP sensor from the vehicle.

Installation Procedure

    Object Number: 1560065 Size: SH
  1. Install the accelerator pedal/APP sensor over the studs.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the accelerator pedal/APP sensor nuts.

    3. Tighten
    Tighten the nuts to 9 N·m (80 lb in).


    Object Number: 1352013 Size: SH
  3. Connect the APP sensor electrical connector.
  4. Inspect below the pedal for binding, to ensure full range of motion.
  5. Install the knee bolster bracket. Refer to Driver Knee Bolster Bracket Replacement .