Step | Action | Yes | No | ||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
Schematic Reference: Interior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views , Data Communication Connector End Views , or Vehicle Access Connector End Views | |||||||||||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |||||||||
2 | Verify that the courtesy/dome lamps are always on. Do the courtesy/dome lamps operate normally? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 | ||||||||
3 | Inspect for the following related body control module (BCM) module data parameters. Refer to Scan Tool Data List and Scan Tool Data Definitions for typical values and definitions:
Was a problem found? | Go to Step 4 | Go to Step 7 | ||||||||
4 | Disconnect and test the switch of the affected input circuit for proper continuity in the open and closed positions. Refer to Circuit Testing. Does the switch operate properly? | Go to Step 5 | Go to Step 6 | ||||||||
5 | Test the signal and ground circuits of the affected input circuit for the following:
Refer to Circuit Testing and Wiring Repairs. Did you find and correct the condition? | Go to Step 11 | Go to Step 7 | ||||||||
6 | Inspect for poor connections at the harness connector of the affected switch. Refer to Circuit Testing and Wiring Repairs. Did you find and correct the condition? | Go to Step 11 | Go to Step 9 | ||||||||
7 | Test for a short to ground in any of the courtesy lamp low control circuits. Refer to Circuit Testing and Wiring Repairs. Did you find and correct the condition? | Go to Step 11 | Go to Step 8 | ||||||||
8 | Inspect for poor connections at the harness connector of the BCM. Refer to Circuit Testing and Wiring Repairs. Did you find and correct the condition? | Go to Step 11 | Go to Step 10 | ||||||||
9 | Replace the switch in the affected circuit. Refer to one of the following replacement procedures as applicable: Did you complete the replacement? | Go to Step 11 | -- | ||||||||
10 | Replace the BCM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 11 | -- | ||||||||
11 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 | ||||||||
