GM Service Manual Online
For 1990-2009 cars only

Parking Brake Indicator Switch Replacement LHD

Removal Procedure


    Object Number: 606395  Size: SH

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the MID-bussed electrical center from the bracket.
  3. Disconnect the park brake warning lamp switch electrical connector.

  4. Object Number: 913316  Size: SH
  5. Remove the park brake warning lamp switch mounting bolt.
  6. Remove the park brake warning lamp switch.

Installation Procedure


    Object Number: 913316  Size: SH
  1. Install the park brake warning lamp switch.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the park brake warning lamp switch mounting bolt.
  4. Tighten
    Tighten the bolt to 3 N·m (25 lb in).


    Object Number: 606395  Size: SH
  5. Connect the park brake warning lamp switch electrical connector.
  6. Install the MID-bussed electrical center to the bracket.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

Parking Brake Indicator Switch Replacement RHD


Object Number: 1869885  Size: MF

Callout

Component Name

Preliminary Procedures

  1. Place the vehicle on a level surface and block the wheels.
  2. Release the park brake lever.
  3. Remove the park brake lever. Refer to Parking Brake Lever Replacement.

1

Park Brake Warning Warning Lamp Switch Bolt

Notice: Refer to Fastener Notice in the Preface section.

Tighten
3 N·m (25 lb in)

2

Park Brake Warning Lamp Switch