GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2007 🢒 H3 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Inside Rearview Mirror Replacement

Removal Procedure
  1. Use a flat-bladed tool in order to remove the wire cover, if equipped.

    2. Object Number: 1453822 Size: SH
  2. Disconnect the electrical connector (4), if equipped.
  3. Using a TORX-head® screwdriver, loosen the set screw that holds the mirror base to the windshield button.
  4. Slide the mirror (3) off of the support.

Installation Procedure

    Object Number: 1453822 Size: SH
  1. Slide the mirror (3) onto the mirror support.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the set screw.

    3. Tighten
    Tighten the set screw to 2 N·m (18 lb in).

  3. Connect the electrical connector (4), if equipped.
  4. Install the wire cover (2), if equipped.
  5. Ensure the wire cover is tucked into the forward edge of the headliner (1).
  6. Re-calibrate the compass. Refer to Compass Calibration and Magnetic Variance .