Caution: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.

Preliminary Procedure

1. Remove the front bucket seat. Refer to Front Seat Replacement - Bucket.
2. Remove the seat cushion trim cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement.
3. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References.
4. Program the inflatable restraint passenger presence system after replacement. Refer to Control Module References.

1

Retainer, Inflatable Restraint Passenger Presence System (Qty: 2)

2

Sensor, Inflatable Restraint Passenger Presence System

Tip
Disconnect the electrical connector.

3

Screw, Inflatable Restraint Passenger Presence System Module (Qty: 2)

Tighten
8 N·m (71 lb in)

4

Module, Inflatable Restraint Passenger Presence System

Tip
Disconnect the electrical connector.