GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2007 🢒 H3 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Seat Belt Retractor Pretensioner Replacement - Front

Object Number: 1563632 Size: MF

Callout

Component Name

Caution: In order to prevent accidental deployment and the risk of personal injury, do not dispose of an undeployed inflatable restraint seat belt pretensioner as normal shop waste. Undeployed seat belt pretensioners contain substances that could cause severe illness or personal injury if their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed seat belt pretensioner. Failure to observe the following disposal methods may be a violation of federal, state, or local laws.

Caution: When carrying an undeployed inflatable restraint seat belt pretensioner:

   • Do not carry the seat belt pretensioner by the wires or connector.
   • Carry the seat belt pretensioner by the piston tube, keeping hands and fingers away from the cable.
   • Make sure the open end of the seat belt pretensioner piston tube points away from you and other people.
   • Do not cover the seat belt pretensioner piston tube opening with your hand.
Failure to observe these guidelines may result in personal injury.

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

  1. Disable the SIR. Refer to SIR Disabling and Enabling.
  2. Remove the center pillar lower trim panel. Refer to Center Pillar Lower Trim Panel Replacement .
  3. Fully deploy the pretensioner before disposal. Refer to Pretensioner Handling and Scrapping .

1

Bolt, Seat Belt Retractor

Tighten
52 N·m (38 lb ft)

2

Adjuster, Shoulder Belt Guide

3

Bolt, Seat Belt Retractor

Tighten
52 N·m (38 lb ft)

4

Bolt, Seat Belt Retractor

Tighten
52 N·m (38 lb ft)

5

Belt Assembly, Retractor Side