Disassembly Procedure
- Remove the differential side bearings. Refer to Differential Side Bearings Replacement .
- Remove the ring gear bolts. Discard the bolts.
- Remove the ring gear from the differential case.
- Remove the differential pinion gears and the differential side gears by performing the following steps:
Important: The ring gear bolts have left-hand threads.
Notice: Do not pry the ring gear from the differential case. Prying the ring gear from the differential case may cause damage to the ring gear and/or the differential case.
Drive the ring gear off with a brass drift if necessary.
| 4.1. | Mark the pinion gears top and bottom and the differential side gears left and right. |
| 4.2. | Remove the pinion shaft lock bolt. |
| 4.3. | Remove the pinion shaft. |
| 4.4. | Roll the differential pinion gears out of the case with the pinion gear thrust washers. |
| 4.5. | Remove the differential side gears and the side gear thrust washers. |
Assembly Procedure
- Lubricate the pinion and side gears using axle lubricant. Use the proper fluid. Refer to Fluid and Lubricant Recommendations .
- Install the differential side gear thrust washers to the differential side gears.
- Install the differential side gears and thrust washers into the differential case.
- Install the differential pinion gears and pinion gear thrust washers by performing the following steps:
- Install the pinion shaft.
- Install a new pinion shaft lock bolt.
- Install the ring gear to the differential case.
- Install the new ring gear bolts.
- Tighten the ring gear bolts. Tighten the bolts alternately and in stages, gradually pulling the ring gear onto the differential case.
- Install the differential side bearings. Refer to Differential Side Bearings Replacement .
If the same differential side gears and the thrust washers are being used, install the gears and the thrust washers to their original locations.
| 4.1. | Position one pinion gear between the differential side gears. |
| 4.2. | Position the second pinion gear between the differential side gears directly opposite the of the first gear. |
| 4.3. | Rotate the differential side gears until the pinion gears is directly opposite the opening in the differential case. |
| 4.4. | Install the thrust washers. |
Rotate the pinion gears toward the differential opening in order to permit the sliding in of the thrust washers.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the new pinion shaft lock bolt to 25 N·m (18 lb ft).
Important: The mating surface of the ring gear and the differential case must be clean and free of burrs before installing the ring gear.
Important: The ring gear bolts have left-hand threads.
Hand start each bolt to ensure that the ring gear is properly installed to the differential case.
Tighten
Tighten the ring gear bolts in sequence to 120 N·m (89 lb ft).
