Rear Axle Shaft Seal and/or Bearing Replacement. HUMMER H3 2007

For 1990-2009 cars only

Makes 🢒 HUMMER 🢒 2007 🢒 H3 🢒 Driveline/Axle 🢒 Rear Drive Axle 🢒 Rear Axle Shaft Seal and/or Bearing Replacement

•	J 8092 Universal Driver Handle-3/4 in - 10

•	J 21128 Axle Pinion Oil Seal Installer (8.6 inch)

•	J 23690 Axle Shaft Bearing Installer (8.6 inch)

•	J 2619-01 Slide Hammer

•	J 45857 Tone Wheel and/or Bearing Remover

Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
Remove the axle shaft. Refer to Rear Axle Shaft Replacement .

Remove the axle shaft seal and the bearing from the axle housing using the J 45857 (1) and the J 2619-01 (2).
To remove the seal only, use a suitable seal remover.

Install the axle shaft bearing using the J 23690 (1) and the J 8092 (2).
Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.

Install the axle shaft seal using the J 21128 .
Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
Install the axle shaft. Refer to Rear Axle Shaft Replacement .
Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Fill the rear axle. Refer to Rear Axle Lubricant Replacement .
Lower the vehicle.