Steering Wheel Inflatable Restraint Module Replacement. HUMMER H3 2007

For 1990-2009 cars only

Makes 🢒 HUMMER 🢒 2007 🢒 H3 🢒 Safety and Security 🢒 Supplemental Inflatable Restraints 🢒 Steering Wheel Inflatable Restraint Module Replacement

Callout	Component Name
Caution: Refer to SIR Inflator Module Handling and Storage Caution in the Preface section. Caution: Refer to SIR Caution in the Preface section. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling. On back side of the steering wheel shroud are 2 openings, place the wheel so that one opening is on top. Using a blunt-ended tool, push the spring fastener inward through the access hole. Repeat the step for the other opening.
1	Module, Steering Wheel Inflatable Restraint Tip Release the connector position assurance (CPA) retainer. Disconnect the electrical connectors. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .

Callout

Component Name

Caution: Refer to SIR Inflator Module Handling and Storage Caution in the Preface section.

Caution: Refer to SIR Caution in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling.
On back side of the steering wheel shroud are 2 openings, place the wheel so that one opening is on top.
Using a blunt-ended tool, push the spring fastener inward through the access hole. Repeat the step for the other opening.

Module, Steering Wheel Inflatable Restraint

Tip

Release the connector position assurance (CPA) retainer.
Disconnect the electrical connectors.
Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .