GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the accessory trim plate. Refer to Instrument Panel Center Trim Panel Replacement .

  2. Object Number: 1251725  Size: SH
  3. Remove the 4 screws that retain the radio to the instrument panel (I/P).
  4. Partially remove the radio disengaging the radio rear alignment locator to gain access to the electrical connectors.

  5. Object Number: 1328319  Size: SH
  6. Disconnect the radio antenna cable.
  7. Disconnect the electrical connectors to the radio.
  8. Remove the radio from the vehicle.

Installation Procedure


    Object Number: 1328319  Size: SH
  1. Position the radio to the I/P.
  2. Connect the electrical connectors to the radio.
  3. Connect the radio antenna cable to the radio.
  4. Position the radio rear alignment locator into the I/P substrate installing the radio to the I/P.
  5. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1251725  Size: SH
  6. Install the 4 screws that retain the radio to the I/P.
  7. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  8. Install the accessory trim plate. Refer to Instrument Panel Center Trim Panel Replacement .
  9. Program the radio after replacement. Refer to Control Module References .