Preliminary Procedures

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement .

1

Plug, Park Brake Adjuster Access

2

Spring, Park Brake Shoe Upper Return

3

Spring, Park Brake Shoe Lower Return

4

Adjuster, Park Brake Shoe

Tip

5

Cap, Park Brake Shoe Retainer Spring (Qty: 2)

6

Spring, Park Brake Shoe Retainer (Qty: 2)

7

Pin, Park Brake Shoe Retainer Spring (Qty: 2)

8

Shoe, Park Brake (Qty: 2)

Tip

1. Set the J 21177-A so that it contacts the inside diameter of the rotor.
2. Position the J 21177-A over the shoe and the lining at the widest point.
3. Turn the adjuster nut until the lining just contacts the J 21177-A .
4. Repeat steps 1-3 for the opposite side.
5. Adjust the park brake cable. Refer to Park Brake Adjustment .