Coolant Heater Replacement With LLR

1. Raise and support the vehicle only high enough to access the coolant heater (6) through the wheelhouse. Refer to Lifting and Jacking the Vehicle .
2. Remove the left wheelhouse liner. Refer to Wheelhouse Panel Replacement .
3. Disconnect the coolant heater cord (4) from the coolant heater (6).
4. Remove the coolant heater from the engine block.

1. Locate the block heater hole on side the block.
2. While lining up the retaining clip on the block heater to notch on block, insert the block heater and snap into place.



3. Connect the coolant heater cord (4) to the coolant heater (6).
4. Install the left wheelhouse liner. Refer to Wheelhouse Panel Replacement .
5. Lower the vehicle.

Coolant Heater Replacement LH8

1. Drain the cooling system/engine block. Refer to Cooling System Draining and Filling.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Remove the oil pan skid plate bolts and plate. Refer to Oil Pan Skid Plate Replacement.
4. Disconnect the coolant heater cord electrical connector.




Important: Do not score the surface of the engine block hole when removing the coolant heater.

5. Remove the coolant heater from the engine block.
6. Remove any burrs, sealer, or other rough spots.

1. If reusing the old coolant heater, apply thread sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent to the threads.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the coolant heater to the engine block.

Tighten
Tighten the coolant heater to 50 N·m (37 lb ft).




3. Connect the coolant heater cord electrical connector.
4. Position and install the oil pan skid plate. Refer to Oil Pan Skid Plate Replacement.
5. Lower the vehicle.
6. Fill the cooling system/engine block. Refer to Cooling System Draining and Filling.