Parking Brake Indicator Switch Replacement LHD

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Remove the MID-bussed electrical center from the bracket.
3. Disconnect the park brake warning lamp switch electrical connector.



4. Remove the park brake warning lamp switch mounting bolt.
5. Remove the park brake warning lamp switch.

1. Install the park brake warning lamp switch.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the park brake warning lamp switch mounting bolt.

Tighten
Tighten the bolt to 3 N·m (25 lb in).




3. Connect the park brake warning lamp switch electrical connector.
4. Install the MID-bussed electrical center to the bracket.
5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

Parking Brake Indicator Switch Replacement RHD