Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

1

Screws, License Plate Lamp (Qty: 2)

Tighten
2 N·m (18 lb in)

2

Connector, License Plate Lamp Assembly (Qty: 1)

Tip
Pull electrical harness slightly rearward to disconnect from socket.

3

Lamp Assembly - Rear License Plate (Qty: 1)

Tip
Hold socket and rotate lens counterclockwise to remove from socket.

4

Bulb, Rear License Plate Lamp (Qty: 1)

Tip
Hold socket and pull bulb straight outward.

1

Rear License Plate Lamp Assembly

Tip
Depress the very small lamp tabs inboard towards the outboard side of the vehicle in order to release the lamps from the impact bar bumper cover.

2

License Plate Lamp Socket

Tip
Twist the lamp socket electrical connector counter-clockwise and remove from the lens housing.

3

License Plate Lamp Bulb