Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

Remove the front wiper module. Refer to Windshield Wiper System Module Replacement .

1

Bolts, Transmission to Wiper Motor (Qty: 2)

Tighten
10 N·m (89 lb in)

2

Motor, Windshield Wiper

Tip

1. The new wiper motor and crank arm position is pre-set, no crank arm to transmission arm alignment is needed.
2. Use a J 39232 Wiper Transmission Separator or equivalent to remove the transmission linkage from the crank arm.
3. Use a J 39529 Transmission Installer or equivalent to secure the transmission linkage to the wiper motor crank arm.