Special Tools

J 45861 ECT Sensor Socket

1. Partially drain the engine coolant below the level of the engine coolant temperature (ECT) sensor. Refer to Cooling System Draining and Filling.



2. Disconnect the ECT sensor electrical connector (2) from the following:

•	The engine wiring harness

•	The camshaft cover (1)

Caution: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

3. Using the J 45861  (4) carefully remove the ECT sensor (3) from the cylinder head (5).

Caution: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

Caution: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.

1. If installing the original sensor or a new sensor without sealant, apply thread sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent.

Caution: Refer to Component Fastener Tightening Caution in the Preface section.

2. Using the J 45861  (4) carefully install the ECT sensor (3) into the cylinder head (5).

Tighten
Tighten the sensor to 14 N·m (10 lb ft).

3. Connect the ECT sensor electrical connector (2) to the following:

•	The engine wiring harness

•	The camshaft cover (1)

4. Fill the engine coolant. Refer to Cooling System Draining and Filling.