GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2009 🢒 H3 🢒 Engine 🢒 Engine Controls and Fuel - 3.7L 🢒 Crankshaft Position Sensor Replacement

Removal Procedure

    Object Number: 1350744 Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Disconnect the engine wiring harness electrical connector (3) from the crankshaft position (CKP) sensor (1).

    3. Object Number: 858202 Size: SH
  3. Remove the CKP sensor bolt.
  4. Remove the CKP sensor from the engine block.

    5. Discard the O-ring seals.

Installation Procedure
  1. Install NEW O-ring seals to the CKP sensor.
  2. Lightly lubricate the O-ring seals with clean engine oil.

    3. Object Number: 858202 Size: SH
  3. Install the CKP sensor into the engine block.
  4. Add sealer GM P/N 12346004 (Canadian P/N 10953480) to the CKP sensor bolt threads.

    5. Caution: Refer to Fastener Caution in the Preface section.

  5. Install the CKP sensor bolt.

    6. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1350744 Size: SH
  6. Connect the engine wiring harness electrical connector (3) to the CKP sensor (1).
  7. Lower the vehicle.
  8. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn.