For 1990-2009 cars only
Removal Procedure
- Open the hood.
- From under the hood, disconnect the secondary air injection (AIR) pump inlet hose quick connect fitting (1) from the pump. Refer to Plastic Collar Quick Connect Fitting Service.
- Disconnect the AIR pump outlet hose quick connect fitting (2) from the pump. Refer to Plastic Collar Quick Connect Fitting Service.
- Remove the engine shield. Refer to Engine Shield Replacement.
- Disconnect the engine wiring harness electrical connector from the AIR pump wiring harness electrical connector.
- Squeeze the AIR pump wiring harness electrical connector clip (1) together and push up in order to separate the clip/connector from the bracket.
- Open the AIR pump wiring harness clip (2) and remove the harness from the clip.
- Remove the AIR pump nuts (1).
- Lower the vehicle.
- Reposition the AIR pump inlet and outlet hoses as necessary in order to remove the pump.
- Remove the AIR pump.
Installation Procedure
- Install the AIR pump.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Install the AIR pump nuts (1).
- Install the AIR pump wiring harness electrical connector clip (1) to the bracket.
- Install the AIR pump wiring harness to the clip (2) and close the clip.
- Connect the engine wiring harness electrical connector to the AIR pump wiring harness electrical connector.
- Install the engine shield. Refer to Engine Shield Replacement.
- Position the AIR pump inlet and outlet hoses as necessary.
- Connect the AIR pump outlet hose quick connect fitting (2) to the pump. Refer to Plastic Collar Quick Connect Fitting Service.
- Connect the AIR pump inlet hose quick connect fitting (1) to the pump. Refer to Plastic Collar Quick Connect Fitting Service.
- Close the hood.
Caution: Refer to Fastener Caution in the Preface section.
Tighten
Tighten the nuts to 9 N·m (80 lb in).
