Special Tools

1. Remove the drive belt. Refer to Drive Belt Replacement.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.



3. Remove the service slot plug.




Note: The crankshaft balancer does not have a key-way; so the crankshaft could turn when tightening, causing an improper torque.

4. Install the EN 46547  (1) into the flywheel teeth.
5. Lower the vehicle.
6. Remove the fan. Refer to Fan Replacement.
7. Remove the fan shroud. Refer to Engine Coolant Fan Shroud Replacement.
8. Drain the engine cooling system. Refer to Cooling System Draining and Filling.
9. Remove the radiator. Refer to Radiator Replacement.



10. Remove and discard the crankshaft balancer bolt.



11. Install the J 41816-2 and J 41816-A to the crankshaft balancer.

Note: Do not pull on outer edge of the crankshaft balancer.

12. Remove the crankshaft balancer.
13. Remove the J 41816-2 and J 41816-A .
14. Remove the crankshaft balancer friction washer.

This will be located at the end of the crankshaft balancer or on the crankshaft.

15. Clean and inspect the crankshaft balancer. Refer to Crankshaft Balancer Cleaning and Inspection.

1. Install the crankshaft balancer using the EN-48034 .
2. Remove the EN-48034 .

Caution: Refer to Fastener Caution in the Preface section.




3. Install the crankshaft balancer washer and a NEW bolt.

Tighten
Tighten the bolt a first pass to 150 N·m (111 lb ft). Using the J 45059 rotate the bolt a final pass an additional 180 degrees.

4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.



5. Remove the EN 46547  (1) from the flywheel teeth.



6. Install the service slot plug.
7. Lower the vehicle.
8. Install the radiator. Refer to Radiator Replacement.
9. Install the fan. Refer to Fan Replacement.
10. Install the fan shroud. Refer to Engine Coolant Fan Shroud Replacement.
11. Install the drive belt. Refer to Drive Belt Replacement.
12. Fill the engine cooling system. Refer to Cooling System Draining and Filling.