GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2009 🢒 H3 🢒 Suspension 🢒 Suspension General Diagnosis 🢒 Stabilizer Shaft Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.

    2. Object Number: 1559081 Size: SH
  2. Remove the nuts from the link assemblies.
  3. Remove the link assemblies.

    4. Object Number: 1559083 Size: SH
  4. Remove the insulator clamp bolts.
  5. Remove the clamps.
  6. Remove the stabilizer shaft.
  7. Remove the insulators.
  8. Inspect all of the parts for wear and damage.

Installation Procedure
  1. Install the insulators to the stabilizer shaft.

    2. Object Number: 1559083 Size: SH
  2. Install the stabilizer shaft.
  3. Install the clamps over the insulators and the stabilizer shaft.

    4. Caution: Refer to Fastener Caution in the Preface section.

  4. Install insulator clamp bolts.

    5. Tighten
    Tighten the bolts to 50 N·m (37 lb ft).

  5. Support the lower control arms at curb height.

    6. Object Number: 1559081 Size: SH
  6. Install the link assemblies.
  7. Install the nuts to the link assemblies.

    8. Tighten
    Tighten the nut to 80 N·m (59 lb ft).

  8. Lower the vehicle.