Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.

1

Side Front Door Emblem (Qty: 1)

1. When removing protective liners from adhesive backed nameplates, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
2. Use a J 25070 or equivalent to remove the old nameplate. Clean all the adhesive residue from the fender, wipe the surface dry with a clean lint-free towel prior to installing new nameplate.
3. Ensure full adhesion is made once the nameplate has been installed.

Tip
Clean and dry thoroughly the area where the emblem will be installed.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.

1

Front Door Nameplate

1. When removing protective liners from adhesive backed nameplates, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
2. Use a J 25070 or equivalent to remove the old nameplate. Clean all the adhesive residue from the fender, wipe the surface dry with a clean lint-free towel prior to installing new nameplate.
3. Ensure full adhesion is made once the nameplate has been installed.

Tip
Clean and dry thoroughly the area where the emblem will be installed.

1

Front Side Door Emblem/Nameplate (H3)

Procedure

1. Use a J 25070 or equivalent to remove the old emblem.
2. Clean all the adhesive residue from the door using a 50/50 solution by volume of isopropyl alcohol and clean drinkable water.
3. Wipe the surface dry with a clean lint-free towel prior to installing new emblem.
4. Close the door.
5. When removing protective liners from adhesive backed emblems, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
6. Position the emblem to the door.
7. Apply palm pressure to the emblem to ensure full adhesion is made to the door.

Special Tools

J 25070 Heat Gun 500-700°F

2

Front Side Door Emblem/Nameplate (T)

Procedure

1. Use a J 25070 or equivalent to remove the old emblem.
2. Clean all the adhesive residue from the door using a 50/50 solution by volume of isopropyl alcohol and clean drinkable water.
3. Wipe the surface dry with a clean lint-free towel prior to installing new emblem.
4. Close the door.
5. When removing protective liners from adhesive backed emblems, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
6. Position the emblem to the door.
7. Apply palm pressure to the emblem to ensure full adhesion is made to the door.