GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2006 🢒 Barina 🢒 Body 🢒 Wipers/Washer Systems 🢒 Windshield Wiper Motor Replacement

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1248430 Size: SH
  1. Disconnect the negative battery cable.
  2. Put the wiper arms in the upright position.
  3. Remove the left side portion of the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  4. Remove the nut securing the wiper arm linkage to the motor drive shaft.

    5. Object Number: 1248432 Size: SH
  5. Pry the wiper arm linkage off the motor drive shaft.
  6. Disconnect the electrical connectors.
  7. Remove the bolts and the wiper motor.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1248432 Size: SH
  1. Install the wiper motor with the bolts.

    2. Tighten
    Tighten the wiper motor bolts to 9 N·m (80 lb in).

  2. Connect the electrical connector.

    3. Object Number: 1248430 Size: SH
  3. Press the wiper arm linkage onto the motor drive shaft.
  4. Install the wiper arm linkage to the motor drive shaft with the nut.

    5. Tighten
    Tighten the wiper arm linkage nut to 8.5 N·m (75 lb in).

  5. Install the left side portion of the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  6. Connect the negative battery cable.