Removal Procedure
Warning: Refer to Battery Disconnect Warning in the Preface section.
- Disconnect the negative battery cable.
- Disconnect the output shaft speed (OSS) sensor electrical connector.
- Remove the OSS sensor retaining bolt.
- Remove the OSS sensor from the transaxle.
Installation Procedure
Note: Lubricate the O-ring with T-IV Automatic Transmission Fluid GM P/N 88900925 (Canadian P/N 22689186).
- Install a new O-ring on the OSS sensor.
Caution: Refer to Fastener Caution in the Preface section.
- Install the OSS sensor.
- Install the OSS sensor bolt and tighten to
7 N·m (62 lb in).
- Connect the OSS sensor electrical connector.
- Connect the negative battery cable.