Removal Procedure
Warning: Refer to Battery Disconnect Warning in the Preface section.
- Disconnect the negative battery cable.
- Disconnect the electronic throttle control (ETC) connector from the accelerator pedal.
- Remove the 3 accelerator pedal retaining nuts.
- Remove the accelerator pedal.
Installation Procedure
- Position the accelerator pedal.
Caution: Refer to Fastener Caution in the Preface section.
- Install the 3 accelerator pedal retaining nuts.
Tighten
Tighten the accelerator pedal retaining nuts to 19 N·m (14 lb ft).
- Connect the ETC connector to the accelerator pedal.
- Connect the negative battery cable.