Heater and Air Conditioning Control Replacement Hatchback
Removal Procedure
Warning: Refer to Battery Disconnect Warning in the Preface section.
- Disconnect the negative battery cable.
- Remove the Instrument panel lower trim panel. Refer to
Instrument Panel Lower Trim Panel Replacement.
- Remove the instrument panel lower center trim. Refer to
Instrument Panel Lower Center Trim Replacement.
- Remove the HVAC controller retaining screws (1).
- Remove the controller (2) by pulling it out to provide clearance for the removal of the cable.
Note: Note the location of the cables and the housings to facilitate their reinstallation.
- Disconnect the mechanical control cables by gently prying off the cable eyelet (2) and unsnapping the cable housing (1) from the mechanical slide.
- Disconnect the electrical connectors.
Installation Procedure
- Connect the electrical connectors to the proper sockets on the back of the controller.
- Install the mechanical cable housings (1) to the proper control positions.
- Install the eyelets (2) on the end of each cable, pressing each onto the proper post.
- Install the controller (2) by gently inserting the controller into the proper position on the instrument panel.
Caution: Refer to Fastener Caution in the Preface section.
- Install the left and the right controller retaining screws (1).
Tighten
Tighten the HVAC controller retaining screws to 3 N·m (27 lb in).
- Install the instrument panel lower center trim. Refer to
Instrument Panel Lower Center Trim Replacement.
- Install the instrument panel lower trim panel. Refer to
Instrument Panel Lower Trim Panel Replacement.
- Connect the negative battery cable.
- Confirm the proper operation of the controller by moving it through all of the controller's possible functioning positions.