Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using the diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC C0060 : Left Front Dump Solenoid Circuit OpenDTC C0065 : Left Front Hold Valve Circuit Open
Circuit/System Description
The solenoid valve coil circuits are supplied with power from the battery when the valve relay is energized. Switched ground is provided by the electronic brake control module (EBCM) to each coil.
This procedure checks whether the left front inlet and outlet valves are functioning.
Conditions for Running the DTC
| • | Vehicle speed is greater than 6 km/h (4 mph) with the brake pedal not applied. |
| OR |
| • | Vehicle speed is greater than 15 km/h (9 mph) and the brake pedal is actuated. |
Conditions for Setting the DTC
| • | A valve has failed. |
| • | A solenoid coil is open or shorted. |
Action Taken When the DTC Sets
| • | The antilock brake system (ABS) is disabled. |
| • | The ABS warning indicator turns ON. |
| • | The electronic brake force distribution (EBD) is disabled. |
If the failure is intermittent, the EBCM will enable the system at the next ignition cycle and set a history DTC.
Conditions for Clearing the DTC
The condition for setting the DTC is no longer present and the DTC is cleared with a scan tool.
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Electrical Information Reference
Scan Tool Reference
Electronic Brake Control Module Scan Tool Information
Circuit/System Verification
Ignition ON, verify that DTC C0060 or C0065 is not set.
| ⇒ | If DTC is set, replace the EBCM/BPMV. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM and BPMV replacement, setup, and programming
