Diagnostic Instructions

DTC Descriptors

DTC B0019 01 : Passenger Frontal Deployment Loop Stage 1 Short to Battery

DTC B0019 02 : Passenger Frontal Deployment Loop Stage 1 Short to Ground

DTC B0019 04 : Passenger Frontal Deployment Loop Stage 1 Open Circuit

DTC B0019 0D : Passenger Frontal Deployment Loop Stage 1 Resistance Above Threshold

DTC B0019 0E : Passenger Frontal Deployment Loop Stage 1 Resistance Below Threshold

Diagnostic Fault Information

Circuit	Short to Ground	High Resistance	Open	Short to Voltage	Signal Performance
I/P Module Stage 1 High Circuit	B0019 02	B0019 0D	B0019 04	B0019 01	B0019 0E
I/P Module Stage 1 Low Circuit	B0019 02	B0019 0D	B0019 04	B0019 01	B0019 0E

Circuit/System Description

If a malfunction is detected, a DTC will be stored in non-volatile memory. During a side or frontal crash of sufficient force the inflatable restraint sensing and diagnostic module (SDM) will allow current to flow through the deployment loop in order to deploy the I/P module. The SDM performs continuous diagnostic tests on the deployment loops to check for proper circuit continuity and for shorts to ground or voltage. There are 2 shorting bars used within the instrument panel (I/P) module connector which will short together both I/P module stage 1 high and low circuits, and both I/P module stage 2 high and low circuits, when the connector is disconnected. This will help to prevent unwanted deployment of the inflator module during servicing.

Conditions for Running the DTC

Ignition voltage is between 9-16 volts.

Conditions for Setting the DTC

B0019 01

The I/P module high and/or low circuit is short to voltage.

B0019 02

The I/P module high and/or low circuit is short to ground.

B0019 04

The I/P module high and/or low circuit is open.

B0019 0D

The I/P module deployment loop resistance is more than 3.54 ohms.

B0019 0E

The I/P module deployment loop resistance is less than 1.77 ohms.

Action Taken When the DTC Sets

Conditions for Clearing the DTC

Reference Information

Schematic Reference

SIR Schematics

Connector End View Reference

SIR Connector End Views

Electrical Information Reference

Circuit/System Testing

Important: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.

•	The I/P module

•	The SDM module

•	The I/P wiring harness connector

•	The SDM wiring harness connector

1. Ignition OFF, open and lower glove box door fully and disconnect I/P module in-line connector.
2. Disconnect the SDM connector. Refer to SDM replacement in Repair Instructions for connector location.
3. Test the high and low circuits between the SDM and I/P module for a short to voltage, short to ground, short between circuits or open/high resistance. Verify that a short to voltage, short to ground, short between circuits or open/high resistance does not exist.

⇒	If any of the above conditions are found make the appropriate repair.

4. If all circuits test normal then replace the SDM.
5. Ignition ON, use a scan tool to observe the SIR DTC display. Verify DTC B0019 is set current.

⇒	Replace the I/P module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.