GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2008 🢒 Captiva 🢒 Brakes 🢒 Park Brake 🢒 Parking Brake Lever Replacement

Removal Procedure

    Object Number: 1764787 Size: SH
  1. Release the park brake.
  2. Remove the console. Refer to Console Replacement .
  3. Measure the thread length from the end of the pull rod to the hex nut.

    4. Object Number: 1764789 Size: SH
  4. Remove the park brake adjustment nut from the eye bolt pull rod.

    5. Object Number: 1764797 Size: SH
  5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  6. Remove the park brake cable ends from the park brake cable equalizer.

    7. Object Number: 1764798 Size: SH
  7. Remove the bolts which secure the park brake lever assembly to the body panel.

    8. Object Number: 1764807 Size: SH

    Important: Replace the park brake warning lamp switch if the BRAKE warning light in the instrument panel cluster did not glow when the park brake was applied with the ignition ON.

  8. Remove the park brake switch from the park brake lever assembly.
  9. Remove the park brake lever.

Installation Procedure

    Object Number: 1764807 Size: SH
  1. Install the park brake warning lamp switch to the park brake lever assembly.

    2. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1764798 Size: SH
  2. Install the park brake lever assembly to the body panel with bolts.

    3. Tighten
    Tighten the park brake lever assembly bolts to 23 N·m (17 lb ft).


    Object Number: 1764797 Size: SH
  3. Install the park brake cable ends to the park brake cable equalizer.
  4. Lower the vehicle.

    5. Object Number: 1764789 Size: SH
  5. Install the park brake adjustment nut to the eye bolt pull rod. Inspect the park brake adjustment by referring to the original removal adjustment nut measurement taken in the removal procedure. Refer to Park Brake Adjustment .
  6. Install the console. Refer to Console Replacement .