Diagnostic Instructions
DTC Descriptors
DTC C0551 45: Option Configuration Error/Variant not programmed
DTC C0551 47: Option Configuration Error/VIN not programmed
Circuit/System Description
The electronic brake control module (EBCM) learns the model options that it is installed in by using the Vehicle ID information from the body control module (BCM) via the class 2 serial data line. Each time the vehicle is in the RUN position the BCM communicates
this information via class 2. The EBCM internally compares the VIN and option information with that information stored in the BCM.
Conditions for Running the DTC
The ignition switch is in the ON position.
Conditions for Setting the DTC
C0551 45
The incorrect EBCM is installed on the vehicle.
C0551 47
The incorrect software or calibrations have been flash programmed into the EBCM.
Action Taken When the DTC Sets
One or more of the following actions may occur:
| • | The EBCM disables the ABS/traction control system (TCS) for the duration of the ignition cycle. |
| • | The ABS indicators turn ON. |
| • | The traction control indicator turns ON. |
| • | The red BRAKE Warning indicator turns ON. |
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present. |
| • | The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Circuit/System Verification
Verify that the EBCM is the correct module for the vehicle.
| ⇒ | If the EBCM is not correct, replace the EBCM. |
Repair Instructions
Perform the
Diagnostic Repair Verification
after completing the diagnostic procedure.
Control Module References
for EBCM replacement, setup, and programming
