GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2009 🢒 Captiva 🢒 Engine 🢒 Engine Controls and Fuel - 2.8L, 3.0L, 3.2L, or 3.6L 🢒 Evaporative Emission Canister Purge Solenoid Valve Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.


    Object Number: 1804758 Size: SH

    Warning: Do not breathe the air through the EVAP component tubes or hoses. The fuel vapors inside the EVAP components may cause personal injury.

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  2. Remove the engine dress cover. Refer to Engine Front Cover Replacement.
  3. Disconnect the wiring harness connector (1) from the evaporative emission (EVAP) canister purge valve (2).
  4. Disconnect the two EVAP canister purge valve hoses (3 and 4).

    5. Object Number: 1804760 Size: SH
  5. Slide the EVAP canister purge valve (1) from the purge valve mounting bracket (2).

    6. Object Number: 1804761 Size: SH
  6. If required, perform the function test of the EVAP canister purge valve as follows:
    7. • Attempt to blow air through the EVAP canister purge valve inlet port (1).
    • If air passes through the valve, the valve is faulty and should be replaced.

Installation Procedure


    Object Number: 1804758 Size: SH
  1. Slide the EVAP canister purge valve to the purge valve mounting bracket.
  2. Connect the two EVAP canister purge valve hoses (3 and 4).
  3. Connect the wiring harness connector (1) to the EVAP canister purge valve (2).
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.