Special Tools

DW-110-060 Engine Assembly Support Fixture

Note: Only lift the engine far enough to take the weight off the transaxle front mount assembly, or damage to the mount and lifting equipment failure may occur.

1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
2. Support the engine assembly using DW-110-060 fixture .



3. Remove the transaxle front mount-to-cradle through bolt.
4. Remove the transaxle front mount retaining bolts from the transaxle.
5. Remove the transaxle front mount assembly.

Caution: Refer to Fastener Caution in the Preface section.




1. Install the transaxle front mount assembly and tighten the bolts to 50 N·m (37 lb ft).

Note: Before tightening the transaxle front mount through bolt swing the engine assembly backwards and forwards or from the side to side for the proper alignment.

2. Install the transaxle front mount through bolt. Tighten the transaxle front mount-to-cradle through bolt to 90 N·m (66 lb ft).
3. Remove DW-110-060 fixture .
4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.