Special Tools
DW-110-060 Engine Assembly Support Fixture
Removal Procedure
Note: Only lift the engine far enough to take the weight off the transaxle rear mount assembly.
- Support the engine assembly using
DW-110-060 fixture
.
- Remove the transaxle rear mount-to-bracket through bolt and nut.
- Remove the transaxle rear mount bracket bolts from the transaxle.
- Remove the transaxle rear mount bracket.
- Remove the transaxle rear mount retaining bolts from the cradle.
- Remove the transaxle rear mount.
Installation Procedure
Caution: Refer to Fastener Caution in the Preface section.
- Install the transaxle rear mount to the cradle and tighten bolts to
90 N·m (66 lb ft).
Note: Before tightening the transaxle front mount through bolt and nut, swing the engine assembly backwards and forwards or from the side to side for the proper alignment.
- Install the transaxle rear mount bracket to the transaxle and tighten bolts to
90 N·m (66 lb ft).
- Install the transaxle rear mount through bolt and nut and tighten to
90 N·m (66 lb ft).