Removal Procedure
Warning: Refer to Battery Disconnect Warning in the Preface section.
- Disconnect the negative battery cable.
- Remove the beauty cover. Refer to
Engine Cover Replacement
- Disconnect the ECM connectors.
- Press the ECM retaining clip between the ECM and bracket using by common plate driver and simultaneously extract the ECM from the bracket upward.
- Remove the ECM bracket.
Installation Procedure
Caution: Refer to Fastener Caution in the Preface section.
- Install the ECM bracket and tighten the retaining nuts to
15 N·m (11.1 lb ft).
- Install the ECM.
Note: If replaced the new ECM, reprogram the ECM for the injectors using by scan tool.
- Connect the ECM connectors.
- Install the beauty cover. Refer to
Engine Cover Replacement.
- Connect the negative battery cable.