Transmission Fluid Pump Disassemble. Holden Epica 2008

For 1990-2009 cars only

Makes 🢒 Holden 🢒 2008 🢒 Epica 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Transmission Fluid Pump Disassemble

Table 1:	Fluid Filter Assembly and Torque Converter Fluid Seal Disassemble
Table 2:	Fluid Pump Disassemble

Callout

Component Name

Fluid Filter Assembly

Tip
Rotate filter 90 degrees to disengage locking tangs.

Torque Converter Fluid Seal Retainer

Torque Converter Fluid Seal

•	J 6125-B Slide Hammer

•	J 23129 Universal Seal Remover

Torque Converter Fluid Seal Assembly

•	J 6125-B Slide Hammer

•	J 23129 Universal Seal Remover

Callout	Component Name
Caution: Valve springs can be tightly compressed. Use care when removing retainers and plugs. Personal injury could result. Notice: After cleaning the transmission components, allow to air dry. Do not use cloth or paper towels in order to dry any transmission components. Lint from the towels can cause component failure. Notice: Do not reuse cleaning solvents. Previously used solvents may deposit sediment which may damage the component. Preliminary Procedure Clean and inspect all valve components and the pump body for wear and/or damage.
1	TCC Control Valve Train
2	Fluid Pump Blow Off Ball Valve Train
3	Pressure Regulator Valve Train
4	TCC Blow Off Ball Valve Train
5	Fluid Pump Cover Bolts M6 x 25 (Qty: 23) Tip There are 3 bolts on the pump cover side and 20 bolts on the pump body side.
6	Fluid Pump Cover
7	Fluid Pump Drive Gear
8	Fluid Pump Driven Gear