The engine control module (ECM) has several 5-volt reference circuits. The ECM provides the 5-volt reference to various sensors. Each reference circuit provides a 5-volt reference for greater than one sensor. A short to ground or voltage on one of the 5-volt reference circuits will affect all components connected to that 5-volt reference circuit. The ECM monitors the voltage on the 5-volt reference 1 and 5-volt reference 2 circuits.

The control module detects a voltage greater than 5.2 volts, or less than 4.8 volts, on either 5-volt reference circuit for greater than 1 second.

DTCs P0652 and P0653 are Type C DTCs.

DTCs P0652 and P0653 are Type C DTCs.

The 5-volt reference 2 circuit provides 5 volts to the following sensors:

If a shared 5-volt reference circuit is shorted to ground or shorted to a voltage, other 5-volt reference circuits may be affected.

Schematic Reference

Engine Controls Schematics

Connector End View Reference

Component Connector End Views

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References for scan tool information

1. Ignition ON, observe the DTC information with a scan tool. DTCs P0642, P0643, P0652, and P0653 should not set.

⇒	If any DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle.

2. Observe the DTC information with a scan tool. DTCs P0652 and P0653 should not set.
3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

Important: Additional DTCs will set when disconnecting the components.

1. Ignition OFF, disconnect the harness connector at all the appropriate sensors for the applicable DTC. Refer to Diagnostic Aids.
2. Ignition ON, test for 4.8-5.2 volts between all of the 5-volt reference circuits and ground.

⇒	If less than the specified range, test the 5-volt reference circuits for a short to ground. If all circuits test normal, replace the ECM.

⇒	If greater than the specified range, test the 5-volt reference circuits for a short to voltage. If all circuits test normal, replace the ECM.

Important: A short to voltage on the signal circuit of certain components may cause this DTC to set.

3. Connect each component associated with the 5-volt reference circuit one at a time while observing the voltage. The voltage should not change greater than 0.5 volt.

⇒	If less than the specified range when a component is connected, replace the component.

⇒	If greater than the specified range when a component is connected, test the signal circuit for a short to voltage. If all circuits test normal, replace the ECM.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.