GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2008 🢒 Epica 🢒 Transmission/Transaxle 🢒 Automatic Transmission - 6T40/6T45 🢒 Transmission Rear Mount Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the left tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Using a suitable jack stand, support the rear of the powertrain.

    4. Object Number: 1998674 Size: SH
  4. Remove the transmission mount to bracket through bolt (1).

    5. Object Number: 1998675 Size: SH
  5. Remove the transaxle brace bolts (1, 3).
  6. Remove the transaxle brace (2).

    7. Object Number: 1998676 Size: SH
  7. Remove the transmission mount to transmission bolts (2).
  8. Remove the transmission mount (1).

Installation Procedure

    Object Number: 1998676 Size: SH
  1. Install the transmission mount (1).

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the transmission mount to transmission bolts (2).

    3. Tighten
    Tighten the bolts to 90 N·m (66 lb ft).


    Object Number: 1998675 Size: SH
  3. Install the transaxle brace (2).
  4. Install the transaxle brace bolt (1).

    5. Tighten
    Tighten the bolt to 50 N·m (37 lb ft).

  5. Install the transaxle brace bolt (3).

    6. Tighten
    Tighten the bolt to 100 N·m (74 lb ft).


    Object Number: 1998674 Size: SH
  6. Install the transmission mount to bracket through bolt (1).

    7. Tighten
    Tighten the bolt to 90 N·m (66 lb ft).

  7. Remove the jack stand.
  8. Install the left tire and wheel. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.