GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Holden
🢒
2009
🢒
Epica
🢒
Diagnostic Navigation
🢒
Vehicle Diagnostic Information
🢒 Accelerator Pedal Position Sensor Replacement
Removal Procedure
Turn the ignition switch to the off position.
Disconnect the electronic throttle control (ETC) connector from the accelerator pedal.
Remove the 3 accelerator pedal retaining bolts.
Remove the accelerator pedal.
Installation Procedure
Position the accelerator pedal.
Caution:
Refer to
Fastener Caution
in the Preface section.
Install the 3 accelerator pedal retaining nuts and tighten.
•
The upper accelerator pedal retaining bolts (1) to
10 N·m (89 lb in)
.
•
The lower accelerator pedal retaining bolt (2) to
23 N·m (17 lb ft)
.
Connect the ETC connector to the accelerator pedal.