Special Tools
• | EN-48304
Fuel Filter Locker Installer/Remover |
Removal Procedure
Warning: Gasoline or gasoline vapors are highly flammable. A fire could occur if an ignition source is present. Never drain or store gasoline or diesel fuel in an open container, due to the possibility
of fire or explosion. Have a dry chemical (Class B) fire extinguisher nearby.
- Disconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection.
- Remove the beauty cover. Refer to
Engine Cover Replacement.
- Remove the battery. Refer to
Battery Replacement.
- Disconnect the fuel inlet/outlet line from the fuel filter.
- Disconnect the fuel heater and temperature sensor connector (1).
- Disconnect the water in fuel sensor connector (2).
- Remove the fuel filter assembly from the bracket by lifting upward.
- Install
EN-48303
and
EN-48304
(2) to the fuel filter assembly.
- Turn
EN-48304
(1) counterclockwise.
- Remove the fuel filter locker (5).
- Remove the fuel filter cap (4) with the O-ring (1).
Note: Do not reuse the fuel filter element if the element is exposed to the air over a minute.
Note: The fuel filter cap contains the fuel heater and temperature sensor. Also, the fuel filter housing contains the water in fuel sensor.
- Remove the fuel filter in the fuel filter housing (2).
Installation Procedure
Note: Do not touch the fuel filter element by hand to prevent fuel contamination.
- Install the fuel filter into the fuel filter housing (2).
- Install the fuel filter cap (4) with a new O-ring (1).
Caution: Refer to Fastener Caution in the Preface section.
- Install the fuel filter locker (5) by using
EN-48303
and
EN-48304
and tighten to
30 N·m (22.1 lb ft).
- Install the fuel filter to the bracket.
- Install the fuel filter bracket to the body using the bracket retaining nut and tighten to
10 N·m (88.5 lb ft).
- Install the battery. Refer to
Battery Replacement.
- Install the beauty cover. Refer to
Engine Cover Replacement.
- Connect the negative battery cable.