GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2009 🢒 Epica 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Engine Oil and Oil Filter Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.


    Object Number: 1863906 Size: SH
  1. Disconnect the negative battery cable.
  2. Remove the beauty cover. Refer to Engine Cover Replacement.
  3. Remove the charge air system hoses and ducts. Refer to Charge Air Cooler Inlet Pipe and Outlet Pipe Replacement.
  4. Remove the fuel filter assembly. Refer to Fuel Filter Replacement.

    5. Object Number: 1822563 Size: SH
  5. Drain the engine oil.
  6. Remove the oil filter housing drain bolt with washer and drain the engine oil in the oil filter housing.
  7. Remove the oil filter cap with the O-ring.

    8. Note: Check the engine oil maintenance interval and replace the engine oil filter according to the interval. Also, you can check the engine oil remaining life in the scan tool.

  8. Remove the oil filter.

    9. Object Number: 1822564 Size: SH
  9. Remove the oil filter housing adapter plate.
  10. Remove the oil filter housing with the O-ring.

Installation Procedure

    Object Number: 1822564 Size: SH
  1. Install the engine oil filter housing with a new O-ring.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the oil filter housing adapter plate and tighten to 40 N·m (29.5 lb ft).

    3. Object Number: 1822563 Size: SH
  3. Install the engine oil filter and cap with a new O-ring and tighten to 25 N·m (18.4 lb ft).
  4. If you changed the engine oil, reset ECM program by using the scan tool.