Circuit Description
The battery in the key fob provides power for all remote keyless functions. You can tell the battery is weak if the LED fails to illuminate or if the transmitter will not work at the normal range in any location. If you have to get close to your vehicle before the transmitter works, it is probably time to change the battery.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC 023 Keyless Entry Transmitter Low Battery
Conditions for Running the DTC
Vehicle battery voltage must be between 9-16 volts.
Conditions for Setting the DTC
The ISU detects low voltage from the key fob.
Action Taken When the DTC Sets
The remote function control will be diminished.
Conditions for Clearing the DTC
| • | The ISU no longer detects a low voltage condition from the key fob. |
| • | A history DTC will clear after 40 consecutive ignition cycles if the condition for the malfunction is no longer present. |
Step | Action | Yes | No |
|---|---|---|---|
|
Important: You must obtain all the keys from the vehicle owner before testing any current keys. If a key needs to be replaced, any vehicle keys not programmed during the programming procedure will be inoperative after the programming sequence is completed. Ensure that the doors, hood and trunk/rear hatch are closed prior to starting the programming procedure. If the system is placed in program mode, then the ISU will erase all previously programmed transmitters upon the receipt of the first transmitter s programming signal. Do not operate or program the transmitters in the vicinity of other vehicles that are also in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle. | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 |
Did you find and correct the condition? | System OK | Go to Symptoms - Keyless Entry |
