Circuit Description
This DTC is used to identify the condition of traction control system (TCS) switch and circuit. The ignition voltage is passing through fuse F9, terminal 2 of connector C202, TCS switch and terminal 14 of EBCM.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC C1503 Traction Control Switch Circuit
Conditions for Running the DTC
Ignition is in the ON position.
Conditions for Setting the DTC
| • | Out of adjustment or shorted TCS switch contact |
| • | TCS switch circuit shorted to battery |
| • | Internal EBCM fault |
Action Taken When the DTC Sets
| • | DTC C1503 is stored. |
| • | TCS disabled, TCS warning lamp turns on. |
Conditions for Clearing the DTC
If the conditions that set DTC C1503 are no longer presents, the DTC can be cleared by scan tool.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Antilock Brake System Schematics Connector End View Reference: Component Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Check fuse F9. Is the fuse OK? | Go to Step 4 | Go to Step 3 |
3 |
Did the DTC Reset? | Go to Step 4 | Go to Step 8 |
4 | Check the terminal 2 of connector C202, wiring harness and terminal 14 of EBCM. Did you find any open or short circuit of the wiring harness or abnormal terminal forms? | Go to Step 5 | Go to Step 6 |
5 | Repair the open or short circuit of the wiring harness and terminals. Did you complete the repair? | Go to Step 8 | -- |
6 |
Did the DTC Reset? | Go to Step 7 | Go to Step 8 |
7 | Replace the EBCM. Did you complete the replacement? | Go to Step 8 | -- |
8 |
Does the DTC reset? | Go to Step 2 | System OK |
