For 1990-2009 cars only
Removal Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Disconnect the brake line from the disc brake hose at the wheel housing bracket on each side of the vehicle.
- Remove the brake hose retainer.
- Remove the rear disc brake hose retainer and the brake hose from the bracket on the steering knuckle shaft.
- Remove the rear disc brake hose from the caliper.
Installation Procedure
- Install the rear disc brake hose to the caliper and tighten to 32 N·m (24 lb ft).
- Install the rear disc brake hose and the retainer on the bracket on the steering knuckle shaft.
- Install the rear disc brake line to the brake hose on the wheel housing bracket and tighten to 16 N·m (12 lb ft).
- Lower the vehicle.
- Bleed the brake system. Refer to Hydraulic Brake System Bleeding.
- Check the brake system for leaks.
Caution: Refer to Fastener Caution in the Preface section.
