For 1990-2009 cars only
Removal Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Place a drain pan or suitable container under the vehicle.
- Remove the inlet pipe union bolt from the radiator.
- Remove the outlet pipe union bolt and the clip bolt from the radiator.
- Remove the oil cooler line assembly bolt from the transaxle.
- Remove the oil cooler line assembly.
- Replace the transaxle oil cooler line seals. Refer to Transmission Fluid Cooler Pipe Seal Replacement.
Installation Procedure
- Install the oil cooler line assembly to the transaxle.
- Install the oil cooler line assembly bolt and tighten to 10 N·m (89 lb in).
- Install the outlet pipe union bolt and the clip bolt to the radiator.
- Install the inlet pipe union bolt to the radiator and tighten to 33 N·m (24 lb ft).
- Lower the vehicle.
- Add fluid to the transaxle.
- Check the fluid level. Refer to Transmission Fluid Replacement.
Caution: Refer to Fastener Caution in the Preface section.
| • | Tighten the outlet pipe union bolt (1) to 33 N·m (24 lb ft). |
| • | Tighten the clip bolt (2) to 9 N·m (80 lb in). |
