For 1990-2009 cars only
Removal Procedure
- Disconnect the negative battery cable.
- Disconnect the return spring from the mount brace.
- Remove the nut, the washer, and the pedal mounting shaft.
- Remove the locking washer and the piston rod bolt.
- Remove the clutch pedal from the vehicle.
Warning: Refer to Battery Disconnect Warning in the Preface section.
Installation Procedure
- Install the clutch pedal to the mount brace. Make sure the return spring engages the notch on the rear of the clutch pedal.
- Coat the piston rod bolt with multi-purpose grease.
- Install the piston rod bolt and the locking washer.
- Coat the pedal mounting shaft with multi-purpose grease.
- Install the pedal mounting shaft, the washer, and the nut and tighten to 18 N·m (13 lb ft).
- Connect the return spring to the mount brace.
- Connect the negative battery cable.
Caution: Refer to Fastener Caution in the Preface section.
