Circuit Description
This DTC is used to identify the condition of communicate area network (CAN) between electronic brake control module (EBCM) and engine control module (ECM) or transaxle control module (TCM).
DTC Descriptor
This diagnostic procedure supports the following DTCs:
| • | DTC C1605 CAN Bus Error |
| • | DTC C1611 CAN Bus Error |
| • | DTC C1612 CAN Bus Error |
| • | DTC C1616 CAN Bus OFF Failure |
Conditions for Running the DTC
Ignition is in the ON position.
Conditions for Setting the DTC
| • | Wiring harness (or connector) between EBCM and ECM (or TCM) is shorted or opened. |
| • | ECM (or TCM) or EBCM internal fault. |
Action Taken When the DTC Sets
| • | DTC C1605, C1611, C1612, C1616 is (are) stored. |
| • | TCS disabled, TCS warning lamp turns on. |
Conditions for Clearing the DTC
If the conditions that the DTC C1605, C1611, C1612, C1616 is (are) no longer present, then the DTC (s) can be cleared by scan tool.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Antilock Brake System Schematics Connector End View Reference: Component Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Check the engine control module (ECM) and transaxle control module (TCM). Did you find any DTCs? | Go to Step 3 | |
3 | Check the wiring, terminal and connectors between the electronic brake control module (EBCM) and the ECM or TCM. Are the wiring, terminals and connectors OK? | Go to Step 5 | Go to Step 4 |
4 |
Did the DTC reset? | Go to Step 5 | Go to Step 6 |
5 | Replace the EBCM. Did you complete the replacement? | Go to Step 6 | -- |
6 |
Does the DTC reset? | Go to Step 2 | System OK |
