GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2008 🢒 Lumina Ute 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Instrument Cluster Replacement

Removal Procedure

    Important: If the IPC is being replaced due to mechanical damage only, store the data on Tech 2 so the new IPC can be relearned using the stored info on the Tech 2.

  1. Remove the knee Bolster. Refer to Knee Bolster Replacement .
  2. Remove the upper steering wheel cover. Refer to Steering Column Trim Covers Replacement .
  3. Remove the instrument cluster trim panel. Refer to Instrument Cluster Trim Panel Replacement .
  4. Lower the steering column.

    5. Object Number: 1957789 Size: SH
  5. Remove the instrument cluster (1) to I/P trim pad retaining screws (2).
  6. Carefully remove the instrument cluster (1) from the instrument panel trim pad.

    7. Object Number: 1962720 Size: SH
  7. Disconnect the instrument cluster (1) electrical connector (2).

    8. Important: When removing the instrument cluster, take care not scratch or damage the instrument cluster screen.

  8. Remove the instrument cluster (1).

Installation Procedure

    Object Number: 1962720 Size: SH
  1. Connect the electrical connector (2) to the Instrument cluster  (1).

    2. Object Number: 1957791 Size: SH

    Important: When installing the instrument cluster, make sure the anti-rattle foam (1) is between the I/P trim pad and instrument cluster.

  2. Install the instrument cluster.

    3. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1957789 Size: SH
  3. Install the instrument cluster (1) retaining screws (2).

    4. Tighten
    Tighten the screws (2) to 2  N·m (18 lb in).

  4. Install the instrument panel (I/P) trim panel. Refer to Instrument Cluster Trim Panel Replacement .
  5. Install the steering wheel upper trim cover. Refer to Steering Column Trim Covers Replacement .
  6. Install the knee bolster. Refer to Knee Bolster Replacement .
  7. Re-programme the instrument cluster. Refer to Instrument Cluster Programming and Setup .