- Remove the third accumulator retainer and ball assembly,
using a 6.3 mm (0.25 in) #4 screw extractor.
- Scribe a mark at 42 mm (1.653 in) on a
9.5 mm (0.375 in) diameter metal rod. The scribe mark is used to gauge
the proper depth of the third accumulator retainer and ball assembly.
- Perform the following functions:
| 3.1. | Line up the oil feed slots in the third accumulator retainer and ball
assembly (40) with the servo bore. |
| 3.2. | Using the 9.5 mm (0.375 in) diameter metal rod, install
the third accumulator retainer and ball assembly. |
- Ensure that the third accumulator retainer and ball
assembly and the scribe mark on the rod are flush with the case surface.
- Check the third accumulator retainer and ball assembly (40)
for alignment. The slot in the retainer must be completely open in the servo bore.
