GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2009 🢒 Sportwagon 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Steering Wheel Control Switch Assembly Replacement

Removal Procedure

    Object Number: 1957906 Size: SH
  1. Disable the occupant protection system. Refer to SIR Disabling and Enabling.
  2. Remove the steering wheel inflatable restraint. Refer to Inflatable Restraint Steering Wheel Module Replacement.
  3. Remove the steering wheel. Refer to Steering Wheel Replacement.
  4. Remove the steering wheel hub to rear cover screws (1).

    5. Object Number: 1957909 Size: SH

    Important: Make sure to disengage the retaining lugs (2).

  5. Remove the rear cover (1) from the steering wheel hub (3).

    6. Object Number: 1957911 Size: SH
  6. Remove the steering wheel hub to steering wheel audio control switch assembly screws (1).
  7. Remove the steering wheel audio control switch assembly harness grounding screw (2).

    8. Object Number: 1957922 Size: SH
  8. Remove the steering wheel hub to steering wheel spoke trim retaining screws (1).
  9. Remove the steering wheel audio control switches from the steering wheel hub assembly.

Installation Procedure

    Object Number: 1957911 Size: SH
  1. Install the steering wheel audio control switches from the steering wheel hub assembly.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the steering wheel audio control switch assembly harness grounding screw (2).

    3. Tighten
    Tighten the screws to 1 N·m (9 lb in).

    Notice: Refer to Fastener Notice in the Preface section.

  3. Install the steering wheel hub to steering wheel audio control switch assembly retaining screws (1).

    4. Tighten
    Tighten the screws to 1 N·m (9 lb in).


    Object Number: 1957909 Size: SH

    Important: Make sure that all the retainers (2) engage.

  4. Install the rear cover (1) to the steering wheel hub (3).

    5. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1957906 Size: SH
  5. Install the steering wheel hub to rear cover retaining screws (1).

    6. Tighten
    Tighten the screws to 1 N·m (9 lb in).

  6. Install the steering wheel. Refer to Steering Wheel Replacement.
  7. Install the steering wheel inflatable restraint. Refer to Inflatable Restraint Steering Wheel Module Replacement.
  8. Enable the occupant protection system. Refer to SIR Disabling and Enabling.